Send Us Email

Home
Link to Buzz Art account on facebook

Your wood engraving specialist

NOTE: We are presently shipping using couriers

FAQ

Q. How long does it take to process my order?
A. For standard products it normaly takes about two weeks, often faster.

Q. How do I order?
A. Check out how to order from the main menu

Q. What payments are permitted?
A. For payment options check out how to order from the main menu

Q. Do you take international orders?
A. We accept Canadian and USA orders.

Q. How do I know my order has been sent?
A. An email notification is sent by the shipping company once your order has been shipped.

Q. What do I have to do to use a sign outdoors?
A. The signs are coated with a marine grade urethane. Till the urethane starts to fade you do not need to do anything. At which point you can lightly sand the sign and apply a couple more coats of oil based urethane

Q. What type of wood is used to make the signs
A. While we can make the signs out of any type of wood our specialty is red cedar

Q. How long does it take to make a sign?
A. The time to make a standard sign is one to two weeks, but sometimes rush orders can be done for a small fee

Q. Do you make custom signs?
A. Yes all our signs are customized as you require for graphics, text, size, color and shape

Q. What is the largest sign you make?
A. While larger signs can be made in multiple parts our CNC can handle wood blands up to 8' * 5'

Q. How do I install the brass hocks that came with the sign
A. The following steps are how we do it
- Open one set of the eyelets by sliding the eyelet down a large flat head screw driver
- You only need to open them about 1-8in
- Along the top locate the center of the sign and then mark the same distance out from the center (we use 5in each side)
- Using a very small drill or pricking tool mark the location.
- Thread the eyelet into the wood

Q. How do I install the screws supplied with the signs
A. The screws are screwed directly through the sign, using the following steps:
- Drill a hole through the sign a little smaller than the outside thread of the screw
- Using a hand screw driver screw the screw in to what ever the sign is being attached to
- Becareful as the screw is brass and very soft. If it becomes tight stop screw and predrill the hole about 1/2 the diameter of the screw thread
- Only sink the screw into just before the beveled edge ends on the screw head. DO NOT make the screw flush

If you have any additional questions do not hestitate to email us